Cost Guides

Bloomington, IL Concrete Driveway Cost

Stoutwell Concrete · November 17, 2026 · 5 min read

new concrete driveway slab divided by control joints beside a house under construction

Our price for a plain broom finish concrete driveway in Bloomington, IL is $5 to $10 per square foot installed. Colored or exposed aggregate concrete is $8 to $14 per square foot and stamped concrete is $10 to $21. Where a driveway lands in that range depends on the finish, the size, the ground under it and its pitch, and the site visit settles the rest.

Every rate is on our pricing page, and our Bloomington hub lists the four services we pour.

A 24 by 24 Foot Driveway in Numbers

Take a two-car driveway 24 feet wide and 24 feet long, which is 576 square feet. At our rates it comes to:

FinishRate per square foot576 square feet
Plain broom$5 to $10$2,880 to $5,760
Colored or exposed aggregate$8 to $14$4,608 to $8,064
Stamped$10 to $21$5,760 to $12,096
Removing an old slab$1 to $4$576 to $2,304

The removal line applies only when an old slab comes out. Each finish row covers base preparation, forms, reinforcement, the pour and the finish itself. Extra grading and the permit step are listed on the written quote as items of their own, so the rate stays easy to read.

Moraine Clay Under the Slab

Bloomington and Normal stand on a pair of low ridges the last glacier built, the Bloomington Moraine and the Normal Moraine. Both are made of till, a fine-grained gray clay the ice left behind. Beside the major valleys and south of the Bloomington Moraine the ground changes to sand and gravel, so two neighboring properties can sit on different material.

For a slab, that comes down to preparation. We cut to firm subgrade, compact a stone base on top of it and set the forms to the fall before any concrete arrives. How deep the base goes is decided at the site visit, and the written quote states the base we will build. Thickness follows the same logic, and our guide to how thick a concrete driveway should be explains the difference between a car-only drive and one that takes delivery trucks.

Making Water Leave the Slab

A driveway that falls toward the garage, or a patio set against the house wall, has to be graded so water runs away from the building. Where a lot sits on a rise, the ground already falls and the work is matching the slab to that slope. Where a lot is nearly level there is no natural fall, so we build one with fill and compacted stone and pitch the concrete toward the low side.

Either way, the extra grading shows as its own line on the written quote, not folded into the per-square-foot rate. That keeps the pour price comparable from one property to the next, and it shows exactly what the ground added.

The City of Bloomington Permit Step

A new or wider driveway entrance cut through the curb reaches into the street. In Bloomington, that goes through the City of Bloomington Engineering permit step, and the city decides what applies to your address. Our written quote lists the step as its own item, so it is part of the schedule from the start and not a surprise in the middle of the job.

We also pour in Normal, Le Roy, Heyworth, Lexington and every other town on our hub.

When a Pour Works Here

About 130 nights a year drop to freezing or below. Most of them fall in winter, about 83 a year, with about 28 more in spring and 21 in fall. In a typical year the last freeze of spring comes near April 21 and the first freeze of fall near October 20, which leaves late April to mid October as the main stretch for placing concrete. Bloomington also gets about 40 inches of precipitation a year, and nearly a third of it falls from June through August, so a summer pour is planned around the forecast and not the calendar.

The practical result is timing. A slab planned for spring or fall has to fit between those dates, and a winter request leaves the weeks before the first workable spring pour to settle the base, the grading and the permit step. To get your own figure, request a free quote.

Frequently asked questions

Is 4 inches of concrete thick enough for a driveway?

Four inches is the baseline for a driveway that carries passenger cars, and 5 inches is the baseline where delivery vehicles will drive on it. Whether a Bloomington driveway gets 4 inches or more is set at the site visit from its use and its ground, and the written quote states the thickness.

How much does a 20 by 40 foot concrete driveway cost?

A 20 by 40 foot driveway is 800 square feet. Multiply that area by the rate for the finish you choose: $5 to $10 per square foot for plain broom, $8 to $14 for colored or exposed aggregate and $10 to $21 for stamped. Removing an old slab adds $1 to $4 per square foot.

What does concrete cost per square foot in Bloomington, Illinois?

Our installed rates are $5 to $10 per square foot for a plain broom finish, $8 to $14 for colored or exposed aggregate and $10 to $21 for stamped concrete. Your own number comes with a free written quote for the property.

Ready for a Free Quote?

Get a free, no-obligation quote for property in Bloomington-Normal and McLean County.

Get Your Free Quote

Or call us directly: (919) 219-2946

Call Free Quote