Cost Guides

Concrete Driveway Apron Cost (2026)

Stoutwell Concrete · November 15, 2026 · 7 min read

concrete driveway running from the street to a garage at the front of a house

A concrete driveway apron costs $5 to $10 per square foot with us for a plain broom finish. A 16 by 10 foot apron, 160 square feet, comes to $800 to $1,600. When an old apron has to come out first, removal is its own line at $1 to $4 per square foot, so the same apron replaced runs $960 to $2,240 all in. These are our installed prices, and your own number comes from a free written quote.

What a Driveway Apron Is

The apron is the stretch of driveway that meets the street. It runs from the curb, or the edge of the road where there is no curb, back to the sidewalk or the property line. On a lot with a public sidewalk, the apron is often the piece between the street and that sidewalk, plus the section of driveway where it crosses the walk.

On many lots, the apron sits in the public right of way, the strip of land along the street that belongs to the city rather than to the house. That is why apron work so often involves a permit, even when the rest of the driveway does not.

Some people also call the wide flare in front of a garage door an apron. Here, apron means the street end, the part that takes the most punishment.

Why the Apron Breaks First

A driveway apron carries more load than any other part of the slab. Every car brakes on it, turns across it and climbs the bump from the street onto it. Delivery trucks, garbage trucks and the occasional moving van roll across the apron and then stop, while the rest of the driveway never sees them.

Water is the other half. The apron sits low, at the bottom of the driveway and next to the street, so it catches runoff from both. Where winters freeze, plowed snow and road salt pile up on it. Water that gets under the edge softens the base, and freeze and thaw open small cracks into big ones.

The result is a familiar pattern: a driveway that is still sound by the garage, with a cracked, sunken or broken apron at the street. Because the apron is its own section, it can usually be replaced on its own.

What a Concrete Apron Costs

An apron is priced by its area, length times width. Three common sizes, with and without removing an old apron:

ApronAreaNew apron, plain broom ($5 to $10)Removal ($1 to $4)Replaced, plain broom with removal
Single drive, 12 by 10 feet120 sq ft$600 to $1,200$120 to $480$720 to $1,680
Standard drive, 16 by 10 feet160 sq ft$800 to $1,600$160 to $640$960 to $2,240
Wide two-car drive, 20 by 12 feet240 sq ft$1,200 to $2,400$240 to $960$1,440 to $3,360

Most aprons get a plain broom finish, because it grips in rain and it matches the street and the sidewalk around it. Where the apron is part of a decorative driveway, colored or exposed aggregate runs $8 to $14 per square foot and stamped runs $10 to $21. A 160 square foot apron in colored or exposed aggregate comes to $1,280 to $2,240 before any removal.

Small aprons tend to land toward the top of the range. Some of the work is the same at any size: getting equipment and concrete to the street, setting up forms, saw cutting and finishing the edges against the road.

What Changes the Price of an Apron

Four things move an apron job up or down the range.

Thickness at the street. Because the apron takes the turning load and the heavy trucks, we usually pour it thicker than the rest of the driveway, with reinforcement planned for the load. More concrete and more steel cost more per square foot.

Saw cutting. To replace an apron without disturbing the driveway behind it, we saw-cut a clean, straight line and break out only the apron. Where the apron meets the street, the edge has to be cut and finished cleanly too.

The curb cut. A new driveway entrance where none existed, or a wider one, may need the curb cut or lowered so cars can roll in. When that is part of the job, it is shown on our quote as its own item.

A sidewalk crossing. Where the driveway crosses a public sidewalk, the walk section in the drive is usually poured as part of the apron and built to the same heavier standard, since cars cross it too. It is priced on the same per square foot basis.

Access and the condition of the base matter as well. A base that has washed out or settled is dug out, refilled and compacted before the pour, and that is part of what makes the new apron outlast the old one.

Permits for Apron Work

Because the apron usually sits in the public right of way, many cities require a permit before it is removed or poured, and some inspect the forms before the concrete goes in. Whether a permit applies depends on where you live. When one does, it is its own line on our written quote, so you can see it apart from the concrete.

Replacing the Apron or the Whole Driveway

If the apron is the only part that has failed and the rest of the slab is level and sound, replacing the apron alone is the cheapest fix. New concrete will look lighter than the old driveway for a while, then settle toward the same color.

If the driveway behind the apron is cracking, sinking or holding water too, a full replacement is usually better value, because it is all removed and poured in one job. Our driveway replacement cost guide works through those totals, and the concrete driveway cost guide prices a new driveway on bare ground. If you want the apron widened or a parking pad added while the forms are out, see our driveway extension cost guide.

Frequently Asked Questions

How much does a concrete driveway apron cost?

Our installed price for a plain broom-finish concrete apron is $5 to $10 per square foot. A 16 by 10 foot apron, 160 square feet, comes to $800 to $1,600. Removing an old apron first adds $1 to $4 per square foot. Your own number comes from a free written quote.

What is a driveway apron?

The apron is the section of driveway between the street and the rest of the drive, usually from the curb or the street edge to the sidewalk or the property line. On many lots it sits in the public right of way rather than on the homeowner’s land.

Why does the driveway apron crack first?

Every car turns onto the apron, brakes on it and climbs over the street edge onto it, and delivery and garbage trucks often roll across it too. It also takes runoff from the street and, in cold places, snowplow piles and salt. That load and water break it down sooner than the rest of the slab.

Can you replace just the driveway apron?

Yes. We saw-cut a clean line between the apron and the driveway, break out and haul away the old apron and pour a new one. It is priced on the apron’s area: removal at $1 to $4 per square foot plus the new concrete at $5 to $10.

Do I need a permit to replace a driveway apron?

Often. Because the apron usually sits in the public right of way, many cities require a permit for apron work. When one applies, it is its own line on our written quote.

How thick should a driveway apron be?

We usually pour the apron thicker than the rest of the driveway, because it takes the turning and braking load and the occasional heavy truck. The exact thickness is set on the quote for your street and how the drive is used.

Get a Driveway Apron Quote

Stoutwell Concrete removes broken aprons and forms and pours new ones, on their own or as part of a new or replaced driveway. Our quote lists the removal, the new concrete and any permit as separate lines, and a look at the street end of the drive makes the written quote final. Request a free quote to get started.

Ready for a Free Quote?

Get a free, no-obligation quote for your property.

Get Your Free Quote

Or call us directly: (919) 219-2946

Call Free Quote