Casper, WY Concrete Driveway Cost
Stoutwell Concrete · November 17, 2026 · 5 min read
Our plain broom finish concrete driveway in Casper runs $5 to $10 per square foot installed. Colored or exposed aggregate concrete runs $8 to $14 per square foot and stamped concrete $10 to $21. Where a driveway lands in those ranges depends on the finish, the size, the ground and the slope, and the site visit settles it. The Casper concrete page lists everything we pour.
How Much a Two-Car Driveway Costs in Casper
Take a two-car driveway, 24 feet by 24 feet, which is 576 square feet. Here is the arithmetic at each of our rates.
| Finish | Our rate per square foot | A 576 square foot drive |
|---|---|---|
| Plain broom | $5 to $10 | $2,880 to $5,760 |
| Colored or exposed aggregate | $8 to $14 | $4,608 to $8,064 |
| Stamped | $10 to $21 | $5,760 to $12,096 |
Removing an old slab is separate: $1 to $4 per square foot, or $576 to $2,304 for the same drive, on its own line. A bigger or smaller drive follows the same rule, area times the rate for the finish. Grading, added base work, cold-weather protection and the city permit step each appear as their own lines on the written quote. The pricing page sets out the four rows.
Where a Casper Driveway Sits in the Range
Four things move a drive within its range. The finish comes first: a plain broom texture sits low, and color, exposed stone or a stamped pattern climbs from there. The size comes second, because every added square foot is another multiple of the rate. Third is the old slab, if one has to come out. Fourth is the lot itself, where a drive that climbs from the street needs more grading than a flat one.
Casper adds a fifth, the calendar. A pour in the cold weeks of spring or fall can need extra protection or a later date, while a mid-summer pour needs the least. How thick the slab should be is a matter of ground and traffic, and the guide to driveway thickness covers the choices. We set the thickness and the base at the site visit.
The Short Pour Season in Casper
Freezing nights are rare from June through August. May still sees about 7 or 8 nights with a low of 32 F or below and September about 3, while April sees about 21 and October about 17. That leaves a short stretch for pouring new concrete, and the dates that fit your project come out of the site visit.
Summer has its own difficulty. July highs average 89 F, about 17 days in July reach 90 F or more, and the whole year brings only about 12 inches of precipitation. So we start a July pour in the cool of the morning and finish the surface before the afternoon heat. We pour an air-entrained mix, and we do not promise a day to drive on a new slab.
Freeze, Thaw and Snow on a Casper Slab
Spring is the hard part for concrete here. In March the low falls to 32 F or below on 26 days, yet the high stays at or below 32 F on just 3, so a slab freezes at night and thaws by day, again and again. Snow averages about 10 inches in April and about 9 inches in November, and it can fall in any month from September through May. Melt and de-icing put water on the surface all winter.
Water that freezes inside concrete is what breaks it up, which is why we pour an air-entrained mix and set the slope so water leaves the slab instead of sitting on it. The slope is set before the forms go in.
Clay Under a Slab in Wyoming
Parts of Wyoming sit on clay that swells when it takes on water and contracts as it dries. Bentonite is the best known, and it forms in some shales and volcanic ash deposits. A slab resting on that ground can crack as the clay moves under it.
Which ground lies under a particular Casper yard shows at the site visit, not before it. If the ground does swell, the base may need more depth or more compaction, and that work is its own line on the quote. If it does not, the line is not there.
The City of Casper Curb-Cut Permit
When a new driveway means removing street curb or curb-walk, the City of Casper requires a curb-cut permit first. The application goes through the city’s online portal. The city decides what applies to your address, so the permit step is listed on the quote and not guessed at. Our services page describes how a driveway job runs from base to finish, and you can request a free quote for yours.
Frequently asked questions
How much does a 20 by 40 foot driveway cost in Casper?
Twenty feet by 40 feet is 800 square feet. Multiply that by our rate for the finish you want: $5 to $10 per square foot for plain broom, $8 to $14 for colored or exposed aggregate, $10 to $21 for stamped. Your free written quote gives the total after the site visit.
What does 1,000 square feet of new concrete cost in Casper?
A 1,000 square foot pour follows the same rule: the area times the rate for the finish. Removing an old slab, extra base work and cold-weather protection are separate lines, and the written quote adds them all up after the site visit.
Is 4 inches of concrete thick enough for a Casper driveway?
The thickness and the base under a driveway depend on the ground and on what will drive over it, so we set both at the site visit and list them on the written quote.
More Concrete Guides
Cost Guides Concrete Driveway Apron Cost (2026)
A concrete driveway apron costs $5 to $10 per sq ft with us: a 16 by 10 foot apron is $800 to $1,600, plus $1 to $4 per sq ft to remove an old one. See totals.
Cost Guides Concrete Removal Cost in 2026
Concrete removal runs $1 to $4 per sq ft with us when we pour new: $576 to $2,304 for a 24 by 24 driveway. See totals for walks, patios and driveways.
Cost Guides Driveway Extension Cost: Widening With Concrete
A concrete driveway extension runs $5 to $10 per sq ft with us; adding 4 feet along a 40 foot drive is $800 to $1,600. See totals for pads and widening.
Ready for a Free Quote?
Get a free, no-obligation quote for property in Casper and Natrona County.
Get Your Free QuoteOr call us directly: (919) 219-2946