Cost Guides

Olive Branch, MS Concrete Driveway Cost

Stoutwell Concrete · October 24, 2026 · 5 min read

freshly poured concrete driveway between wood forms, running up to a new garage

Our installed price for a plain broom finish concrete driveway in Olive Branch, Mississippi, runs $5 to $10 per square foot, colored or exposed aggregate runs $8 to $14, and stamped concrete runs $10 to $21. Where a drive lands in those ranges depends on the finish, the size, the ground under the slab and the pitch of the lot, and the site visit settles each one before the written quote is final.

Our Rates for an Olive Branch Driveway, Two-Car Total Included

A two-car driveway of 24 by 24 feet covers 576 square feet. At our rates it comes to the totals below.

FinishRate per square foot24 by 24 foot driveway (576 sq ft)
Plain broom finish$5 to $10$2,880 to $5,760
Colored or exposed aggregate$8 to $14$4,608 to $8,064
Stamped$10 to $21$5,760 to $12,096

Taking out an old driveway runs $1 to $4 per square foot, which is $576 to $2,304 for a slab that size. It is a separate line on the quote, so the new pour is never buried inside a tear-out figure.

The rate covers base preparation, forms, reinforcement, the pour and the finish you choose. Extra grading on a sloped lot, removal and any step the city asks for at the street are itemized on the written quote. The Olive Branch hub lists the four services we pour, and the pricing page shows each rate by service. To see what your own lot comes to, request a free quote.

Silt Soil and the Dense Layer Under Olive Branch Yards

The ground under Olive Branch yards is silt, a fine soil that holds a load poorly. Beneath it sits a dense layer that drains slowly. It begins roughly two feet down, shallower in some yards and deeper in others, so water from a wet winter and spring settles above it instead of draining away. Low ground beside a creek is wetter again.

Silt swells and shrinks far less than heavy clay does, so the trouble on this ground is strength and drainage, not a slab being pushed upward. What lies under one yard is settled at the site visit: how deep the soft silt runs, where the dense layer begins and whether an old slab or earlier backfill is in the way.

Keeping Silty Ground Dry Beneath the Slab

Our base work answers that ground in three steps. Soft or wet silt is dug out down to firm soil. Compacted stone goes back in layers, so the slab rests on stone that drains instead of on silt that stays soft. Then the pitch is set so rain runs off toward the street or the lawn and away from the garage and the house wall.

Thickness works together with the base. Four inches is the minimum we pour for cars, and a drive that will take heavier vehicles is poured thicker; the thickness guide shows how thickness, base and joints fit together. Extra dig-out and stone can change from one Olive Branch yard to the next, and the quote lists them as their own line.

Planning the Apron Where the Drive Reaches the Street

The apron is the stretch of slab where the driveway meets the street. Before forms go up there, we check with the City of Olive Branch about what it asks for that work, and whatever approval step applies is a line on your written quote. A widened drive or a walk that reaches the street gets the same check.

For a job outside Olive Branch, the check goes to that town’s own office or, outside any town’s limits, to the county. The quote names the step, so nothing about the street edge comes as a surprise after the forms are set.

Hot Summers, Freezing Nights and Scheduling a Pour

Near Olive Branch about seventy days a year reach 90 degrees, and about seventy nights a year fall to freezing, with those nights running from November into March. Spring brings the heaviest rain of the year.

On a hot afternoon concrete sets quickly and a stamped surface gets less time to work, so summer pours go in early in the day. In winter, forms are not set over frozen ground and concrete is not placed on a freezing night. Wet stretches in spring move base work to the next dry day. The pour date is set around the forecast once the quote is accepted.

Frequently asked questions

What rate applies to a 500 square foot Olive Branch driveway?

A 500 square foot drive is priced at our rate for the finish you choose: $5 to $10 per square foot for plain broom, $8 to $14 for colored or exposed aggregate and $10 to $21 for stamped. The written quote applies that rate to the area measured at the site visit.

Is a 4 inch slab enough for an Olive Branch driveway?

Four inches is the minimum we pour for a driveway that carries cars. A drive that will take delivery trucks or an RV is poured thicker, and on silty ground the compacted stone base under the slab matters as much as the thickness.

What does widening a driveway cost per square foot?

A widening is priced at the rate for the finish you choose, from $5 to $10 per square foot for plain broom up to $10 to $21 for stamped, with any old slab removal at $1 to $4 per square foot on its own line.

Ready for a Free Quote?

Get a free, no-obligation quote for property in Olive Branch and DeSoto County.

Get Your Free Quote

Or call us directly: (919) 219-2946

Call Free Quote