Rapid City, SD Concrete Driveway Cost
Stoutwell Concrete · November 17, 2026 · 5 min read
Our plain broom finish concrete driveway in Rapid City, SD runs $5 to $10 per square foot installed. Colored or exposed aggregate concrete runs $8 to $14 and stamped concrete $10 to $21 per square foot. The finish, the size, the slope of the lot and the ground set the final figure, and the free written quote settles it after the site visit.
Rapid City sits at the edge of the Black Hills, with hills on one side and prairie on the other. That tilts some lots and brings hard summer storms, and both change how we plan a pour.
Our Price Per Square Foot, Finish by Finish
| Finish or work | Our installed price |
|---|---|
| Plain broom finish | $5 to $10 per square foot |
| Colored or exposed aggregate | $8 to $14 per square foot |
| Stamped | $10 to $21 per square foot |
| Removing an old slab | $1 to $4 per square foot |
Measure the drive’s length times its width to get its area. A 24 by 24 foot two-car driveway is 576 square feet, which comes to $2,880 to $5,760 in a plain broom finish, and removing an old slab first is $576 to $2,304. For a number on your own drive, request a free quote.
What Our Per Square Foot Price Covers
The price includes the base preparation, the forms, the reinforcement, the pour and the finish you chose, all quoted after a site visit. Removing an old slab, extra grading on a slope and the city’s permit step are listed on the written quote as their own lines.
Thickness is part of that visit. We set it by how the drive will be used and what lies under it, and the quote says what we will pour. The guide to how thick a concrete driveway should be explains the usual choices.
Hillside Lots and the Cost of Cut and Fill
A lot on the foothill side of town may climb from the street or drop toward the garage, while a lot out on the flatter ground may need little shaping. The visit measures the fall, because the pitch of the drive decides where water goes.
Where a lot climbs, we cut and fill to give the slab a steady pitch and a path for runoff away from the house. That grading is its own line on the quote.
Parts of the east side of the city are built on shale that swells when it takes on water, and a deep cut into a slope can undermine the ground above it. We do not guess at that from the street. The site visit shows what the lot needs, and the base gets more stone or a drainage path where it calls for one.
Summer Hail and When We Book a Pour
Of all the severe weather in western South Dakota, large hail comes most often, above all near and just east of the Black Hills. Golf ball stones are common in summer, hail the size of a baseball or larger is likely several times a year, and storm warnings mostly come between late May and August.
So we book pours around the forecast and keep covers ready for fresh concrete. May is the wettest month of the year here, with about 3.5 inches of precipitation against about 2.9 in June, so a spring pour is watched as closely as a summer one.
The shoulder seasons ask for a different plan. Overnight lows in April and October still average near freezing, so a pour in either month is planned around the forecast and protected from the cold. How long a slab needs before it takes weight is covered in how long concrete takes to cure, and we tell you when yours is ready.
The City Approach Permit at the Street
A new or widened approach in Rapid City goes through the City of Rapid City’s permit step, and the city decides what applies at your address.
That step goes into the schedule from the start, and it appears on our written quote as its own item.
We serve fourteen places around Rapid City, from Box Elder and Rapid Valley in Pennington County to Summerset and Piedmont in Meade County and Hermosa in Custer County. Our Rapid City concrete driveway page lists the towns we serve, and the pricing page lays out the same rates service by service.
Frequently asked questions
Is 4 inches of concrete enough for a driveway?
That is settled at the site visit. How thick we pour depends on how the drive is used, the base under it and the slope, and the written quote states the thickness for your drive.
How much does a 20 by 40 foot driveway cost in Rapid City?
A 20 by 40 foot driveway is 800 square feet. Our plain broom rate is $5 to $10 per square foot installed, and the free quote sets the total after the site visit.
How long should I stay off a new concrete driveway?
We do not promise a date. The weather and the mix decide, and a cool or wet stretch slows things down. We tell you when the slab is ready for foot traffic and for vehicles.
Is it better to repair or replace a cracked concrete driveway?
We replace. Crack repair and resurfacing are not part of our work, and removing the old slab runs $1 to $4 per square foot before the new slab is poured.
More Concrete Guides
Cost Guides Concrete Driveway Apron Cost (2026)
A concrete driveway apron costs $5 to $10 per sq ft with us: a 16 by 10 foot apron is $800 to $1,600, plus $1 to $4 per sq ft to remove an old one. See totals.
Cost Guides Concrete Removal Cost in 2026
Concrete removal runs $1 to $4 per sq ft with us when we pour new: $576 to $2,304 for a 24 by 24 driveway. See totals for walks, patios and driveways.
Cost Guides Driveway Extension Cost: Widening With Concrete
A concrete driveway extension runs $5 to $10 per sq ft with us; adding 4 feet along a 40 foot drive is $800 to $1,600. See totals for pads and widening.
Ready for a Free Quote?
Get a free, no-obligation quote for property in Rapid City and the Black Hills.
Get Your Free QuoteOr call us directly: (919) 219-2946