new broom-finish concrete driveway with formed edges leading to a garage under construction

Vestavia Hills Concrete Driveways, Patios & Stamped Concrete

Replace a cracked driveway or a bare backyard with new concrete, formed and poured across Vestavia Hills and Jefferson County.

Why Choose Us

Free QuotesDriveways, Patios & Stamped ConcreteJefferson County & Nearby
Free Quotes
Driveways, Patios & Stamped Concrete
Jefferson County & Nearby

From Cracked Slab to New Concrete in 3 Steps

From a free quote to a finished driveway or patio.

1

Request a Free Quote

It's free and there's no obligation.

2

We Form and Pour Your Concrete

We prepare the base, then form and pour the slab.

3

Use Your New Driveway or Patio

A finished driveway, patio or walk in the finish you chose.

What to Know About Concrete in Vestavia Hills, AL

Steep ground. Slopes are steep across much of Vestavia Hills, and on some lots rock sits a foot to a few feet under the topsoil. The site visit shows how deep the base can be cut.

Summer heat. July highs near Vestavia Hills run in the low 90s. A pour is set for a cooler morning on a dry day, so the surface is finished before the heat dries it.

The city permit. A new driveway in Vestavia Hills needs the city's Driveway Permit. For repairs to an existing drive, the City Engineering Department decides the permit and inspection. Your quote lists the permit step.

Stoutwell Concrete serves Vestavia Hills, Alabama, and the Jefferson County and Shelby County towns around it with driveways, patios, walkways and stamped concrete. What a Vestavia Hills drive adds up to, from the finish to the street edge, is worked through in our Vestavia Hills driveway cost guide. The right slab depends on the soil, the drainage, local permit rules and how the surface will be used. Requirements vary by site, scope and jurisdiction; the city or county permit office, and a site visit before the quote is final, determine what applies.

Ranges for every kind of work are on the Vestavia Hills, AL pricing guide, and what each service includes is on the Vestavia Hills, AL services page.

Towns We Serve Around Vestavia Hills

The towns around Vestavia Hills in Jefferson and Shelby Counties, Alabama, from Mountain Brook and Homewood over to Pelham and Chelsea.

Vestavia Hills Mountain Brook Homewood Hoover Irondale Leeds Trussville Center Point Bessemer Hueytown Pelham Helena Alabaster Chelsea

Concrete Questions in Vestavia Hills

What does a concrete driveway cost in Vestavia Hills?
Our plain broom finish runs $5 to $10 a square foot installed. A 24 by 24 foot two-car driveway is 576 square feet, or $2,880 to $5,760. Colored and stamped finishes cost more, and your figure comes in a free written quote.
Can you pour a driveway on a steep lot?
Yes. The pitch is worked out before the forms go up, so water leaves the slab and runs away from the house. Extra cutting or filling on a steep lot is its own line on the quote.
Does rock under the topsoil change the job?
It can. Where rock sits close to the surface, the base is cut to what the lot allows and the slab goes on a compacted bed. The site visit shows how deep the rock is.
Does tear-out cost extra on a Vestavia Hills replacement?
Yes. Removing the old slab runs $1 to $4 per square foot and is a separate line on the quote, apart from the new pour.
Who can pour commercial concrete for a Vestavia Hills property?
Stoutwell Concrete forms and pours dumpster and equipment pads, loading aprons, curb and gutter, sidewalks, ramps and lot sections in Vestavia Hills and across Jefferson and Shelby Counties, but never foundations or structural slabs. Request a free quote.

Get Your Free Concrete Quote

Request a free quote for your driveway, patio or walkway.

Get a Free Quote

Or call us directly: (919) 219-2946

Call Free Quote