Guides

Broom Finish Concrete: Cost, Look and Grip

Stoutwell Concrete · November 15, 2026 · 6 min read

close-up of broom finish concrete texture with control joints

A broom finish is the plain, lightly grooved texture on most driveways and sidewalks, made by pulling a stiff broom across fresh concrete. It costs $5 to $10 per square foot installed with us, so a 24 by 24 foot two-car driveway comes to $2,880 to $5,760. It is our standard finish because it is the lowest cost finish we pour and the one with the best grip.

What a Broom Finish Is

After concrete is placed and leveled, it is floated and troweled to bring a smooth layer of cream to the top and close the surface. Before it sets hard, we drag a wide broom across the slab in one direction. The bristles cut fine parallel grooves into that smooth surface.

Those grooves do two jobs. They give tires and shoes something to grip, wet or dry, and they break up the glare of a flat gray surface. The finish is part of the slab, so it does not peel or wear off like a coating, though it softens slowly under traffic over time.

Light, Medium and Heavy Broom

The texture depends on the broom and how hard it is pulled.

Light broom. A soft broom pulled lightly leaves fine, shallow lines. It feels nearly smooth underfoot and looks clean. It suits a patio, a covered porch slab or a walk where looks matter more than maximum grip.

Medium broom. A medium-stiff broom leaves clear lines you can feel with your hand. It is the usual choice for driveways and front walks: enough grip for rain, easy to sweep and shovel.

Heavy broom. A stiff broom pulled hard leaves deep, rough grooves. It gives the most grip, for a steep driveway or a ramp, but it holds dirt and is harder on bare feet and on a snow shovel.

We set the texture on the quote based on the slope and how the surface will be used.

Which Way the Broom Lines Run

Broom lines should run across the slope and across the direction of travel. On a driveway that falls toward the street, the lines run side to side, so tires climbing the drive meet each groove head on. On a walk, the lines run across the walk, not along it, so a foot stepping forward lands across the grooves.

Lines that run with the slope give less grip, because a sliding tire or shoe can follow the grooves downhill. Keeping the lines straight and even across the whole slab also makes the finish look tidy, which matters on a driveway seen from the street.

Why Broom Finish Is the Standard Driveway Finish

Most driveways, sidewalks and aprons get a broom finish for plain reasons:

  • Grip. It holds tires and shoes in rain, frost and wet leaves better than any smooth finish.
  • Cost. At $5 to $10 per square foot, it is our lowest priced finish.
  • Upkeep. It hides small marks and tire scuffs, sweeps clean and does not need a sealer to look right.
  • It matches. It blends with the street, the public sidewalk and most neighboring driveways.

Here is what broom finish comes to at common sizes:

SurfaceAreaBroom finish ($5 to $10)
Front walk, 4 by 30 feet120 sq ft$600 to $1,200
Patio, 16 by 20 feet320 sq ft$1,600 to $3,200
Two-car driveway, 24 by 24 feet576 sq ft$2,880 to $5,760

Removing an old slab first is its own line at $1 to $4 per square foot. All our finishes and prices are on our pricing page, and our concrete driveway service covers new and replaced drives.

Other Concrete Finishes We Pour

Broom is the plain finish. When you want more color or texture, these are the other finishes we pour:

FinishOur installed priceWhat it looks likeBest for
Broom$5 to $10 per sq ftFine parallel grooves, plain grayDriveways, walks, aprons
Colored$8 to $14 per sq ftBroom or smooth texture in a tan, gray, brown or red toneDriveways and patios that should match the house
Exposed aggregate$8 to $14 per sq ftTop layer washed off to show the stones in the mixDriveways and walks wanting texture and grip
Stamped$10 to $21 per sq ftPressed stone, brick or wood pattern with colorPatios, walks, pool decks, driveway borders

Smooth trowel. A hard troweled surface with no broom texture is flat and easy to clean, but it is slick when wet, so outdoors we keep it to edges and borders, such as a smooth band framing a broom finish field.

Colored concrete. Color mixed into the concrete runs all the way through, so chips and wear do not show gray. It can carry a broom texture on top for grip.

Exposed aggregate. After the pour, the top layer of cement paste is washed away to show the stones underneath. It grips well and hides dirt, which makes it a good driveway finish.

Stamped. A pattern of stone, brick or wood is pressed into the fresh surface, with a second color in the low spots. Our stamped concrete patterns guide explains each pattern and where it fits.

Frequently Asked Questions

What is a broom finish on concrete?

A broom finish is a texture made by dragging a stiff broom across fresh concrete after it has been floated and troweled. The bristles leave fine parallel grooves that give the surface grip, especially when it is wet.

How much does broom finish concrete cost?

Our installed price for broom finish concrete is $5 to $10 per square foot. A 24 by 24 foot two-car driveway, 576 square feet, comes to $2,880 to $5,760. Your own number comes from a free written quote.

Which direction should a broom finish go?

Across the slope and across the direction people walk or drive. On a driveway that runs down to the street, the broom lines run side to side, so tires and shoes meet the grooves head on.

What is the difference between light and heavy broom finish?

A light broom uses a soft broom for fine, shallow lines that feel smooth underfoot. A heavy broom uses stiffer bristles for deep, rough grooves with the most grip. A medium broom sits between them and suits most driveways and walks.

Is a broom finish slippery?

No, a broom finish is the grippiest plain finish we pour, which is why it is the standard for driveways, walks and aprons. A smooth troweled finish is much slicker when wet.

Can a broom finish be sealed?

Yes. A clear penetrating sealer keeps water and salt out without filling the grooves. Resealing later is ordinary upkeep, not a service we sell.

Get a Broom Finish Concrete Quote

Stoutwell Concrete forms and pours broom finish driveways, patios, walks and sidewalk sections, along with colored, exposed aggregate and stamped finishes. A look at the site makes the written quote final. Request a free quote to get started.

Ready for a Free Quote?

Get a free, no-obligation quote for your property.

Get Your Free Quote

Or call us directly: (919) 219-2946

Call Free Quote