Concrete Driveway Cost in Wilmington, NC
Our installed price for a plain broom finish in Wilmington runs $5 to $10 per square foot. Colored or exposed aggregate runs $8 to $14 and a stamped pattern $10 to $21, and your own number comes from a free written quote.
The Wilmington driveway cost guide and the national driveway cost guide walk through how an area turns into a figure. The right slab depends on the soil, the drainage, local permit rules and how the surface will be used. Requirements vary by site, scope and jurisdiction; the city or county permit office, and a site visit before the quote is final, determine what applies.
What each finish involves is on the Wilmington, NC services page, and the towns we serve are on the Wilmington, NC page.
Our Concrete Prices for the Wilmington Area
Concrete Driveways
$5 to $10 per sq ft
Plain broom finish, installed. Color in the mix or exposed stone runs $8 to $14 per square foot, and breaking out an old drive first adds $1 to $4.
Concrete Patios
$5 to $10 per sq ft
Poured at driveway rates, with the fall set so rain leaves the slab. The price follows the size of the patio and the finish you pick.
Stamped & Decorative Concrete
$10 to $21 per sq ft
A pressed pattern on a drive, patio or walk. The pattern and the number of colors move the price; plain color or exposed stone is $8 to $14.
Concrete Walkways & Sidewalks
$5 to $10 per sq ft
Front walks and side paths, poured at the same rate as a driveway. Width and the meeting point with the porch are measured at the visit.
Every figure on this page is our installed price per square foot. The number for your property arrives in a free written quote. Final scope and pricing are confirmed after the site has been inspected and the project requirements have been documented.
What Moves a Wilmington Concrete Quote
The Finish You Pick
A plain broom finish sits at the low end, color in the mix or exposed stone moves a job up a band, and a stamped pattern sits at the top. A drive and a patio can carry different finishes.
Water Close to the Surface
Where winter water sits near the top of the ground, the base may need extra work to drain. That work is listed on the quote as its own line, apart from the per-square-foot rate.
Taking Out an Old Slab
Replacing a drive starts with demolition, which adds $1 to $4 per square foot. Whether the broken concrete can be loaded out at the street is what the site visit checks.
Runoff on Level Lots
On a low, level lot the grading question is less about climbing and more about where the water goes. Extra grading to carry runoff away from the house is itemized on the quote.
The City Permit Step
Inside Wilmington, the city stakes the alignment and an inspector checks forms and subgrade before the pour. The permit step sits inside the schedule, and your written quote shows it as its own item.
Wilmington Concrete Cost Questions
What is the per-square-foot price of a plain Wilmington driveway?
Does a high water table raise the price?
Is the city permit part of the price?
Is a patio priced like a driveway?
Get Your Free Concrete Quote
Request a free quote for your driveway, patio or walkway.
Get a Free QuoteOr call us directly: (919) 219-2946