Concrete Driveway Cost in Canyon Lake, TX
What we charge for a plain broom finish around Canyon Lake is $5 to $10 per square foot, installed. Colored or exposed aggregate comes to $8 to $14 and stamped to $10 to $21. After the site visit, your free written quote puts a figure on your own lot.
The Canyon Lake driveway cost guide and the national driveway guide work through the arithmetic. The right slab depends on the soil, the drainage, local permit rules and how the surface will be used. Requirements vary by site, scope and jurisdiction; the city or county permit office, and a site visit before the quote is final, determine what applies.
What each finish involves is on the Canyon Lake, TX services page, and the towns we serve are on the Canyon Lake, TX page.
Our Concrete Prices for the Canyon Lake Area
Concrete Driveways
$5 to $10 per sq ft
Plain broom, installed. Color or exposed aggregate is $8 to $14 per square foot; hauling out an old slab is $1 to $4 per square foot, on a separate line.
Concrete Patios
$5 to $10 per sq ft
Plain broom, installed, at the driveway rate. Backyard grade and how a concrete truck reaches the spot move the figure inside the range.
Stamped & Decorative Concrete
$10 to $21 per sq ft
A pattern and color pressed into a drive or patio, installed. A busier pattern or an extra color moves the price toward the top.
Concrete Walkways & Sidewalks
$5 to $10 per sq ft
Plain broom, installed. In unincorporated Comal County, a walk inside a county road right-of-way brings in the county permit step; steps and steep runs are listed apart.
The figure for your property comes in a free written quote after the site visit. Final scope and pricing are confirmed after the site has been inspected and the project requirements have been documented.
Commercial Flatwork
Lot Sections & Small Lots
$5 to $10 per sq ft
A cut-out section replaced or a small lot poured, with the base cut or built up evenly where limestone rises near the surface.
Pads & Aprons
$5 to $10 per sq ft
Loading, equipment and dumpster pads, started early on summer mornings. On a 288 square foot pad, 12 by 24 feet, the price is $1,440 to $2,880.
Sidewalks & Ramps
$5 to $10 per sq ft
In unincorporated Comal County, a sidewalk in a county road right-of-way needs the county's Permit to Construct first. A walk's price follows its area; each ramp is priced alone.
Curb & Gutter
Quoted per job
Priced after the site visit. In unincorporated Comal County, where curb meets a county road's side ditch, the ditch must keep draining.
What Moves the Price of a Canyon Lake Concrete Job
The Finish You Choose
The low end belongs to plain broom concrete. Color, exposed stone and stamping each move a job up, so a stamped back patio can sit beside a broom-finished drive.
Taking Out an Old Slab
Breaking out and hauling off an existing drive is $1 to $4 per square foot. For a 576 square foot slab that is $576 to $2,304, shown apart from the pour.
Grading a Sloped Lot
Many lots here fall toward the lake or a ditch. Cutting and filling so the drive drains, and routing its water to one side, is its own line.
Base Work on Shallow Ground
Digging and compacting go differently where rock is close to the surface. What the visit finds decides the base work listed on the quote.
The County Road Edge
In unincorporated Comal County, a drive that meets a county road needs the county permit, its two county visits and, at a side ditch, a culvert built to county standards. The quote lists the permit step.
Canyon Lake Concrete Cost FAQ
What does a two-car concrete driveway cost in Canyon Lake?
Is removing the old driveway priced separately?
Does a long hillside driveway cost more?
Does the county permit change the price?
Get Your Free Concrete Quote
Request a free quote for your driveway, patio or walkway.
Get a Free QuoteOr call us directly: (919) 219-2946