Concrete Driveway Cost in Kaysville, UT

We charge $5 to $10 per square foot, installed, for a plain broom finish in Kaysville. Colored or exposed aggregate is $8 to $14 and stamped concrete is $10 to $21. A free written quote, made final after the site visit, gives the figure for your own property.

For sizes and examples see the Kaysville driveway cost guide; the national guide to driveway pricing covers the general math. The right slab depends on the soil, the drainage, local permit rules and how the surface will be used. Requirements vary by site, scope and jurisdiction; the city or county permit office, and a site visit before the quote is final, determine what applies.

What each finish involves is on the Kaysville, UT services page, and the towns we serve are on the Kaysville, UT page.

Our Concrete Prices for the Kaysville Area

Concrete Driveways

$5 to $10 per sq ft

A broom-finished drive priced by the square foot. Color or exposed aggregate moves it to $8 to $14, and removing the old drive adds $1 to $4 per square foot.

Concrete Patios

$5 to $10 per sq ft

The same rate as a driveway for a plain broom finish. Patios fall slightly away from the house wall, and that pitch is part of the base work.

Stamped & Decorative Concrete

$10 to $21 per sq ft

A pressed pattern and color on a drive or patio. The detail of the pattern and the color scheme decide where in the range a job lands.

Concrete Walkways & Sidewalks

$5 to $10 per sq ft

A plain broom finish at the driveway rate. A walk meeting the drive or the porch step is tied into both, and a short run keeps that rate.

Your own figure comes in a free written quote after the site visit. Final scope and pricing are confirmed after the site has been inspected and the project requirements have been documented.

Commercial Flatwork

Lot Sections & Small Lots

$5 to $10 per sq ft

Lot sections that have worn out, and small new lots. Where spring groundwater rises on the lower west side, the base gets extra stone.

Pads & Aprons

$5 to $10 per sq ft

$1,440 to $2,880 covers a 12 by 24 foot pad of 288 square feet, for dumpster, equipment or loading use.

Sidewalks & Ramps

$5 to $10 per sq ft

Walks priced on square footage, each ramp on its own. Inside Kaysville, walks in the strip from a foot inside the sidewalk to the street take a Public Works permit.

Curb & Gutter

Quoted per job

Measured on site. Inside Kaysville, curb and gutter along a street sit in City right-of-way, so the Public Works permit and Excavation Permit go on the quote.

What Moves a Kaysville Concrete Quote

The Finish You Choose

A plain broom finish sits at the low end of the range. Color, exposed aggregate and stamped patterns each carry a higher per-foot rate, so the finish makes the largest difference to the total.

Taking Out the Old Slab

Removing a worn driveway adds $1 to $4 per square foot and is listed as its own line, so the demolition never hides inside the pour price. On a 24 by 24 foot drive that is $576 to $2,304.

Slope and Drainage

Bench lots that climb toward the mountains need the pitch of the slab and the water's exit planned before anything is poured. The extra cut and fill that fall requires is added to the quote.

Base Work on This Ground

Gravelly bench ground needs little beyond compaction. Silty clay loam on the lower west side can call for extra base stone and drainage planning, which we measure at the site visit and list on the quote.

The Street-Side Permit Step

Concrete that reaches the right-of-way strip by the street takes a Public Works permit through the city, and that step is listed on the written quote. The visit shows whether yours does.

Kaysville Concrete Cost Questions

Is removing an old driveway priced separately?
Yes. Removal runs $1 to $4 per square foot and appears as its own line on the written quote, so the tear-out and the new pour never blur together and each can be read on its own.
Does a sloped lot cost more?
It can. A lot that falls toward the street may need more grading, and a steep drive can add forming work. The site visit measures the fall, and the added work is listed before the quote is final.
What does a patio cost per square foot?
A plain broom patio runs $5 to $10 per square foot, the same rate as a driveway. Color or exposed aggregate runs $8 to $14 and stamping $10 to $21, and the quote shows which one applies.
Does the permit change the quote?
Only if the slab reaches the right-of-way strip by the street. In that case the city's Public Works permit step is listed on the written quote as its own item, separate from the concrete.

Get Your Free Concrete Quote

Request a free quote for your driveway, patio or walkway.

Get a Free Quote

Or call us directly: (919) 219-2946

Call Free Quote