Concrete Driveway Cost in Austin, TX

Finish, tear-out and the ground decide where an Austin job lands. Plain broom finish typically costs $5 to $10 per square foot installed; color or exposed aggregate, $8 to $14; stamped, $10 to $21. These are our installed prices around Austin.

A site visit makes the free written quote final; our guide to concrete driveway cost explains the ranges. How the ground and the city permit work here is covered in our Austin soil guide and our Austin driveway permit guide. The right slab depends on the soil, the drainage, local permit rules and how the surface will be used. Requirements vary by site, scope and jurisdiction; the city or county permit office, and a site visit before the quote is final, determine what applies.

What each finish involves is on the Austin, TX services page, and the towns we serve are on the Austin, TX page.

Our Concrete Prices for the Austin Area

Concrete Driveways

$5 to $10 per sq ft

Plain broom finish, installed. Color or exposed aggregate: $8 to $14 per square foot. Removing an old slab typically adds $1 to $4 per square foot.

Concrete Patios

$5 to $10 per sq ft

Plain broom finish, installed, borrowed from driveway pricing. Your patio's number comes with the free quote, made final once grade, ground and the route to the backyard are seen.

Stamped & Decorative Concrete

$10 to $21 per sq ft

Installed, stamped driveway or patio; pattern detail and color move it within the range. Color or exposed aggregate alone costs $8 to $14 per square foot.

Concrete Walkways & Sidewalks

$5 to $10 per sq ft

Plain broom finish, installed, from the same driveway figures. A walk reaching the curb raises the city permit question, and even a narrow walk gets a prepared base.

These are our installed prices. Your written quote is free. Final scope and pricing are confirmed after the site has been inspected and the project requirements have been documented.

What Shifts the Price of an Austin Concrete Job

Finish You Choose

A brushed finish costs least. Color, exposed stone or stamping each costs more, and one project can mix them, such as a stamped patio beside a plain walk.

Removing the Old Slab

Breaking out and hauling off an old driveway runs a typical $1 to $4 per square foot. Thick or reinforced concrete takes longer to break up, and truck access matters too.

Which Side of Travis County

A sloped western lot can need more forming, grading and drainage work than a flat eastern one, which can raise the price within its range.

Shallow Rock or Deep Clay

Either kind of ground can call for extra base and joint work, and any added preparation appears on the written quote.

The City's Driveway Permit

Work at the curb or sidewalk may need the city's permit. Learning early whether yours does protects the schedule, and the city sets any fee.

Austin Concrete Cost FAQ

Does tearing out an old Austin driveway cost extra?
Yes. Removal is priced on top of the new concrete, at $1 to $4 per square foot. A look at the site confirms the amount and access, and removal gets its own line on your free quote.
What is a reasonable per-square-foot budget for an Austin driveway?
Our plain broom-finish driveway runs $5 to $10 per square foot, installed. Stamped and colored finishes cost more, and your own figure comes from the free quote once someone has seen the site.
Would shallow rock or clay raise my price?
It can. Either kind of ground may need more base work, shown as its own line on the written quote. We size that when we see the lot.
Does the city driveway permit change what a project costs?
It can add time and paperwork. The City of Austin posts its own permit fees, so ask the city for the current figure before budgeting around it.

Get a Real Number for Your Austin Property

Your free written quote is made final once a look at the site has covered grade, ground, drainage and the route in for equipment.

Request a Free Quote

Or call us directly: (919) 219-2946

Call Free Quote