Cost Guides

Concrete Driveway Cost in Wyoming (2026)

Stoutwell Concrete · October 10, 2026 · 7 min read

close-up of stamped concrete with a flagstone pattern

A concrete driveway in Wyoming typically costs $5 to $10 per square foot installed for a plain broom finish. Your own number comes from a free written quote. In Wyoming the weather shapes that number: a short pour season, a long first winter and a state highway permit if your drive meets one.

At a glance:

  • Broom-finished, a 24 by 24 foot pad for two cars (576 sq ft) works out to $2,880 to $5,760, with any tear-out on top.
  • NOAA’s 1991 to 2020 normals count 211.9 nights a year at or below 32 F in Laramie, 183.1 in Casper and 170.4 in Cheyenne, so the pour calendar can move the quote.
  • Laramie logs 54.2 days a year when the high stays at or below 32 F, so a new slab there may sit through long cold spells.
  • Cheyenne licenses each contractor company together with a qualified supervisor; ask your own city or county what it requires before you hire.
  • A driveway apron on a state highway needs a WYDOT access permit before any work in the right-of-way.

What Does a Concrete Driveway Cost in Wyoming?

Measure the slab first, because the price is per square foot of finished concrete (the national driveway cost guide walks through measuring). Then the finish picks the rate:

Finish or serviceOur installed priceWhere it tends to go in Wyoming
Plain broom finish$5 to $10 per square footThe everyday Wyoming drive; brushed grooves keep tires from spinning on frost, melt and wind-packed snow
Colored or exposed aggregate$8 to $14 per square footA front approach or the strip where the drive meets the walk, picked for looks on a short summer pour
Stamped$10 to $21 per square footUsually an apron, walk or patio; see the stamped concrete cost guide
Removing an old slab$1 to $4 per square footOlder drives broken up by long winters, and a chance to rebuild the base before the new pour

These are our installed prices. Within a range, the pour date, the weather protection, the length of the drive and the truck’s reach move the quote.

What Changes the Price of a Driveway in Wyoming

Freezing nights stretch the season (the scheduling line). Cheyenne logs 48.2 freezing nights between March and May and 38.3 between September and November; Casper logs 54.6 and 43.9. NRMCA, the ready-mix trade group, defines cold weather concreting as more than three days with an average temperature under 40 F, and says fresh concrete must stay unfrozen until it reaches 500 psi, roughly two days after placement. A pour in those shoulder months may need blankets, warmed material and forms and base free of frost, listed as its own line on the quote.

Weeks of highs below freezing (the first-winter line). Rock Springs counts 61.8 days a year when the high stays at or below 32 F, Laramie 54.2 and Casper 41.4. NRMCA says concrete that will be wet and exposed to freezing and thawing should be air-entrained, so a Wyoming quote ought to name an air-entrained mix and say when the sealer goes on. The guide to cracks in concrete driveways shows what freeze damage looks like when that was skipped.

Snow load and plow blades (the aftercare line). Normal snowfall is 71.8 inches a year in Casper, 62.9 in Cheyenne and 54.0 in Rock Springs. A steel blade dragged over a young edge can chip it before it has cured. Use a plastic shovel, spread sand for traction, and keep chemical de-icers off a slab in its first winter.

Hot, dry afternoons in the north-central basin (the summer line). Casper reaches 90 F or more on 37.8 days a year and Sheridan on 34.5. Water leaves a fresh slab fast in that weather, so a July pour may want an early start, a curing plan and joints cut on time. How long concrete takes to cure explains when the drive can carry a truck.

Permits on state highways (the lead-time line). WYDOT’s Access Manual says a complete access application should be accepted or denied within four weeks, and that an approach built without a permit can be removed at the landowner’s expense. A drive onto a state highway can therefore carry lead time that a drive onto a side street does not.

Wyoming’s Plains, Basins and Mountains

Cheyenne and the southeast plains

Cheyenne logs 170.4 freezing nights a year and 7.8 nights at or below 0 F. It also logs 14.9 days at 90 F or more, so one season can bring both heat and frost. Aim for late spring to early fall; an October date may call for a cold weather plan.

Laramie and the high plains

Laramie logs 211.9 nights at or below 32 F and 22.7 at or below 0 F, but just 2.5 days at 90 F. Ask for the cold weather plan in writing for any pour outside midsummer.

Casper, Sheridan and Rock Springs

Casper (183.1 freezing nights, 71.8 inches of snow) and Sheridan (184.7 freezing nights) swing from hard winters to hot afternoons, so the plan may need to cover both ends. Rock Springs logs 188.6 freezing nights and 61.8 days with highs at or below 32 F, so ask how a new slab gets through its first winter.

Whichever of these towns you are near, include your city or ZIP code in the quote request.

What to Check Before You Hire in Wyoming

Start with your city or county, which decide what license a contractor needs to work there. In Cheyenne, the Compliance Division licenses a contractor company and its Individual Qualified Supervisor as a pair, so ask a Cheyenne bidder for both numbers. Elsewhere, call the city or county building office, ask what a driveway contractor must hold, and confirm the bidder’s number with them. Either way, the written quote is the document to read closely.

Ask who handles the permit. When a driveway meets a state highway, WYDOT requires an access permit from the District Engineer before work in the right-of-way starts, and once WYDOT accepts the approach it maintains it inside the right-of-way except for snow and debris removal. City and county streets follow their own rules.

Last, put the cold weather questions to every bidder: the lowest temperature they will pour in, how the slab is covered for its first two days, the air content of the mix and the sealing date. The guide to finding a reliable concrete contractor covers more.

Frequently Asked Questions

How much does a concrete driveway cost in Wyoming?

Plan on $5 to $10 per square foot installed for a plain broom finish in Wyoming, or $2,880 to $5,760 for a 24 by 24 foot two-car drive before any tear-out. Exposed aggregate or color moves the rate to $8 to $14, and a stamped pattern to $10 to $21. Because the pour date matters so much here, your own figure comes from a free written quote.

Does Wyoming’s cold make a driveway cost more?

It can. Cheyenne logs 170.4 nights a year at or below 32 F, and Laramie logs 211.9, so a spring or fall pour may need covers, a warmed mix or a later date. Ask for the cold weather plan as its own line; a bid without one may have left a cost out.

Do I need a permit for a driveway in Wyoming?

Where the driveway meets a state highway, yes. The Wyoming Department of Transportation (WYDOT) requires an access permit from the District Engineer, and no work in the highway right-of-way may start before you hold the approved copy. City and county streets have their own rules, so ask your city or county before you sign.

Who checks a concrete contractor’s license in Wyoming?

Your city or county is the place to ask. Cheyenne, for example, licenses a contractor company and its Individual Qualified Supervisor as a pair through its Compliance Division. Ask each bidder for the license your city requires and confirm the number with the city before you sign.

Get a Concrete Driveway Quote in Wyoming

Request a free quote.

Ready for a Free Quote?

Get a free, no-obligation quote for your property in Wyoming.

Get Your Free Quote

Or call us directly: (919) 219-2946

Call Free Quote